Installation

￭ Ensure the sawblade turns in the same direction as the spindle does.If not,accidents are likely to occur.

￭ Choose the flange whose inner diameter is the same as that of the sawblade but the outer diameter is a little larger than 1/3 (for multi-rip saw blade is 1/2 ) of the saw blade. Ensure the flange is clean, not over worn,bent and distorted shape.

￭ Check the tolerance between the sawblade and the spindle.Install the flange and fasten the screw.

￭ Be sure no people stand in front of the machine when starting the machine.Do not feed,just to check whether there is any vibration,radial or axial run out.

￭ Sawblade reprocessing such as bore trimming or reboring,should be finished by the factory.Poor reprocessing would lead to poor quality and may cause injuries.

￭ While installation, the sawblade should be 5~6 teeth highter than the board surface.